Eco-friendly Waterborne Semiconductor Inks Using Surfactant

A research team from Korea succeeded to develop a technology to produce environmentally friendly water-borne semiconductor inks using surfactant. The result is expected to be applied to various electronic devices with a semiconductor surface control technique.

Professor Dae Sung Chung from the Department of Energy Science and Engineering

A research team of Energy Science and Engineering at DGIST has developed a technology to produce environmentally friendly water-borne semiconductor inks using surfactant, which is additives that mix substances of different properties and a component of soap.

Polymer semiconductors are carbon compounds showing the electrical properties of semiconductors. It has been highlighted as a next-generation material of wearable smart devices, etc. not only because they are flexible and light in weight, but also they can be processed in a wide area a low cost through the solution process. However, there is an issue that it causes significant environmental pollution as toxic organic solvents are used in the process.

Despite the limitations, the research team has developed a semiconductor surface control technique using surfactants for environmentally friendly semiconductor manufacturing processes that do not use toxic organic solvents and has produced water-borne semiconductor inks.

In the study, the newly developed waterborne semiconductor ink of the research team has small colloidal particles and less surfactant micelles compared to the waterborne semiconductor inks in the previous studies. As a result, it has a relatively flat surface than the conventional waterborne semiconductor inks. The black and white image in the figure shows the comparison of the surface of the thin film made with the waterborne semiconductor ink developed in this study and conventional one.

According to the research team, the technique is expected to be applied in various electronic devices such as P-type and N-type transistors as well as PN diodes, complementary inverters, photodiodes as high-quality thin films.
Professor Chung stressed the significance of the study by stating "This research has fundamentally solved the environmental pollution problem generated during the production of organic semiconductor, which is spotlighted as the core material of wearable electronic devices. We have developed a source technology that can disperse various semiconductor materials into water through the simple chemical modification. We expect that it can be used in various optoelectronic devices ranging from transistors to solar cell, composite circuit, and image sensor.”

This study has been published as the cover thesis of the Energy & Environmental Science, an international journal of Energy, on November 8. The study was conducted with the support of Basic Research Support Project (Individual Research) by the Ministry of Science and ICT.

For more information, please contact:
Associate Professor Dae Sung Chung
Department of Energy Science and Engineering
Daegu Gyeongbuk Institute of Science and Technology (DGIST)
E-mail: [email protected]

Figure

A comparison of the waterborne semiconductor ink of this study and that of the previous studies

Published: 24 Nov 2017

Contact details:

DGIST PR

333, Techno jungang-daero, Hyeonpung-myeon, Dalseong-gun, Daegu, 42988

+82-53-785-1135
Country: 
Journal:
News topics: 
Academic discipline: 
Content type: 
Websites: 

http://dx.doi.org/10.1039/c7ee01943b Research Paper on Journal of Energy & Environmental Science https://eedldgist.wixsite.com/eedl Laboratory of Eco Energy Device

Reference: 

Jangwhan Cho, Seongwon Yoon, Kyu Min Sim, et al., "Universal selection rule for surfactants used in miniemulsion processes for eco-friendly and high performance polymer semiconductors", Energy & Environmental Science, November 2017